Bradford White® Gas Water Heater, 50 gal Capacity, 40000 Btu/hr BTU, 12.3 kW, 88 gal/hr First Hour Delivery, 0.6 Energy Factor, 45 gal/hr at 90 deg F Temperature Rise Recovery, 78% Recovery Efficiency, 3 in ID x 5 in OD Vent, Flexible Vent, 3/4 in NPT Water, 1/2 in Gas Connection, 150 lb/sq-in Working, 300 lb/sq-in Test Pressure, Natural Gas Fuel, Piezo Ignition, 72-1/2 in H x 22 in Dia
BTU Rating |
: |
40000 Btu/hr |
Capacity |
: |
50 gal |
Connection Type |
: |
3/4 in NPT Water, 1/2 in Gas |
Dimensions |
: |
72-1/2 in H x 22 in Dia |
Efficiency |
: |
78% Recovery |
Energy Factor |
: |
0.6 |
First Hour Delivery |
: |
88 gal/hr |
Fuel Type |
: |
Natural Gas |
Ignition System |
: |
Piezo |
Power Rating |
: |
12.3 kW |
Pressure Rating |
: |
150 lb/sq-in Working, 300 lb/sq-in Test |
Recovery Rate |
: |
45 gal/hr at 90 deg F Temperature Rise |
Vent Size |
: |
3 in ID x 5 in OD |
Vent Type |
: |
Flexible |
- Intelligent gas control with proven millivolt powered technology
- Proprietary algorithms provide enhanced first hr delivery ratings and tighter temperature differentials
- Micro-processor constantly monitors and controls burner operation to maintain consistent and accurate water temperature levels
- An exclusive green LED light prompts the installer during start-up and provides 10-different diagnostic codes to assist in troubleshooting
- Flashing green LED provides positive indication that pilot is on
- High strength advanced polymer composite thermowell provides isolation between electric temperature sensor and surrounding water, no need to drain the tank when removing gas valve
- All air for combustion is taken directly from the outside, the co-axial vent pipe (pipe inside a pipe) draws combustion air in through the outer pipe and exhausts the products of combustion through the inner pipe
- Reinforced seals surround the closed combustion chamber and the FVIR inner door, preventing the ignition of flammable vapors outside of the water heater
- The vent piping and the closed combustion chamber with reinforced seals does not require regular cleaning under normal operating conditions
- Sight window offers a view into the combustion chamber to observe the operation of the pilot and burner
- Factory installed Hydrojet total performance system
- An exclusively engineered enamel formula that provides superior tank protection from the highly corrosive effects of hot water
- Cast aluminum air intake boot provides exceptional installation durability
- 2 in non-CFC foam insulation covers surrounds the tank surface, saving energy by reducing the amount of heat loss
- Pedestal base, factory installed heat traps
- Protective magnesium anode rods
- Temperature and pressure relief valve included
- Durable tamper-proof design low restriction brass drain valve
- Less than 40 ng/J NOx emissions
- 6 or 10 years limited tank and component parts warranties