Contact 1-800-314-3578

Bradford White® RG2PDV75H6N ERP_003535
  1. pin-int

Bradford White® RG2PDV75H6N ERP_003535

Bradford White® RG2PDV75H6N Gas Water Heater, 75 gal Capacity, 80000 Btu/hr BTU, 23.4 kW, Natural Gas Fuel, 110 VAC

  • Manufacturer: Bradford White Corporation
  • Brand Name: Bradford White®
  • Part Number: ERP_003535
  • MPN: RG2PDV75H6N
  • Min. Order Qty: 1
  • Qty. Interval: 1
    • Sign In for Availability

Bradford White® Gas Water Heater, 75 gal Capacity, 80000 Btu/hr BTU, 23.4 kW, 86 gal/hr at 90 deg F Temperature Rise Recovery, 78% Recovery Efficiency, 3 or 4 in Dia Vent, 3.1 A, 110 VAC, 60 Hz, 3/4 in NPT Water, 1/2 in Gas Connection, 150 lb/sq-in Working, 300 lb/sq-in Test Pressure, Natural Gas Fuel, Spark to Pilot Ignition, 70 in H x 35 in Dia

Amperage Rating      :      3.1 A
BTU Rating      :      80000 Btu/hr
Capacity      :      75 gal
Connection Type      :      3/4 in NPT Water, 1/2 in Gas
Dimensions      :      70 in H x 35 in Dia
Efficiency      :      78% Recovery
Frequency Rating      :      60 Hz
Fuel Type      :      Natural Gas
Ignition System      :      Spark to Pilot
Power Rating      :      23.4 kW
Pressure Rating      :      150 lb/sq-in Working, 300 lb/sq-in Test
Recovery Rate      :      86 gal/hr at 90 deg F Temperature Rise
Vent Size      :      3 or 4 in Dia
Voltage Rating      :      110 VAC
  • Intelligent gas control with spark to pilot ignition system eliminates the constant burning pilot
  • Proprietary algorithms provide enhanced first hr delivery ratings and tighter temperature differentials
  • Micro-processor constantly monitors and controls burner operation to maintain consistent and accurate water temperature levels
  • An exclusive green LED light prompts the installer during start-up and provides 10-different diagnostic codes to assist in troubleshooting
  • High strength advanced polymer composite thermowell provides isolation between electric temperature sensor and surrounding water, no need to drain the tank when removing gas valve
  • Closed combustion venting system
  • Cast aluminum air intake boot design provides exceptional durability during installation and operation
  • Termination fitting provides for only 1 exit opening through a wall or roof
  • Electronic sensor prevents burner operation if flammable vapors are detected
  • Factory installed Hydrojet total performance system
  • An exclusively engineered enamel formula that provides superior tank protection from the highly corrosive effects of hot water
  • 2 in non-CFC foam insulation covers the side and top, reducing the amount of heat loss
  • Factory installed heat traps
  • Protective magnesium anode rods
  • Temperature and pressure relief valve included
  • Durable tamper-proof design low restriction brass drain valve
  • 6 or 10 years limited tank and component parts warranties