Contact 1-800-314-3578
The Dixell XC10 Controls replace old Mechanical Pressure Switches that are inaccurate, difficult and time consuming to set up. The XC Controls can directly control a compressor and up to 2 fans. It is possible to control the pressure values of the suction and discharging lines by using a new low cost ratio-metric pressure sensor input. With the addition of a fixed Pressure Switch you can Shut down (and save) the compressor on High Pressure Alarm conditions. A Service Menu records information on Starts, Run Times, Manual Starts, and Alarms.
Dixell Digital Temperature Controller, Series: XC10, 20 A Compressor Output, 230 VAC, Configuration: SPST, +/-0.7 deg C +/-1 Digit Accuracy, 50/60 Hz, 10.5 mm high Display with red LED and icons Display, Temperature Settings: 14 - 131 deg F, Panel in a 71 x 29 mm Panel Cut-Out Mounting
| Accuracy | : | +/-0.7 deg C +/-1 Digit |
| Amperage Rating | : | 20 A Compressor Output |
| Configuration | : | SPST |
| Display Type | : | 10.5 mm high Display with red LED and icons |
| Frequency Rating | : | 50/60 Hz |
| Mounting Type | : | Panel in a 71 x 29 mm Panel Cut-Out |
| Temperature Settings | : | 14 - 131 deg F |
| Voltage Rating | : | 230 VAC |
- Smart error pressure probe management
- External trigger signal to enable regulation
- Flooded start protection
- Suction and discharging lines temperature control
- Compressor working time and activation counters
- Safety control of high pressure and high condensing/suction temperature
- Fan cycling management to share the working load
- Direct access to alarm menu, working time and load activation
- Hot key or prog tool kit connector for quick and easy programming
- 3 VAC max power absorption
Catalog