Contact 1-800-314-3578
Zoeller® Sump Pump, M63 Model, 115 VAC, 9.7 A, 60 Hz, 3/10 hp, 1550 rev/min Speed, 43 gal/min, 1 -Phase, 1-1/2 in NPT Discharge, 10 ft L Cord, 43 gal at 5 ft, 34 gal at 10 ft, 19 gal at 15 ft Capacity, 19.25 ft Max Feet of Head, 130 deg F, Cast Iron Impeller, Cast Iron, 10-1/16 in L x 7-7/8 in W x 10-1/16 in H
| Amperage Rating | : | 9.7 A |
| Capacity | : | 43 gal at 5 ft, 34 gal at 10 ft, 19 gal at 15 ft |
| Cord Length | : | 10 ft |
| Dimensions | : | 10-1/16 in L x 7-7/8 in W x 10-1/16 in H |
| Discharge Size | : | 1-1/2 in NPT |
| Flow Rate | : | 43 gal/min |
| Frequency Rating | : | 60 Hz |
| HP Rating | : | 3/10 hp |
| Impeller Material | : | Cast Iron |
| Material | : | Cast Iron |
| Maximum Feet of Head | : | 19.25 ft |
| Model | : | M63 |
| Phase | : | 1 |
| Speed Rating | : | 1550 rev/min |
| Temperature Rating | : | 130 deg F |
| Voltage Rating | : | 115 VAC |
- Float-operated, submersible, two-pole mechanical switch integrating advanced switch technology
- Corrosion-resistant powder-coated epoxy finish
- Viton outer switch boot
- No sheet metal parts to rust or corrode
- Stainless steel screws, switch arm, guard and handle
- No screens to clog
- Watertight, neoprene square ring between motor and pump housing
- Solid, buoyant, polypropylene float
- Oil-filled, hermetically-sealed, automatic reset thermal overload protected motor
- Upper and lower sleeve bearings running in bath of oil
- Entire unit pressure-tested after assembly
- Carbon and ceramic shaft seal
- Passes 1/2 in spherical solids
- 7-1/4 in on point
- 3 in off-point
- Watertight and dust-tight
- Permanently oiled bearings
Instruction/Installation Manual